Features:
RDL RC2-ST Remote Control Audio Switch 2x1
- Remote Selection of 2 Audio Sources, Destinations or Functions
- Single‑Button Selection for Each Source
- Open‑collector Switching of 1 of 2 Module Functions
- 3‑wire or 4‑wire Remote Wiring
- Professional Aesthetic Appearance
- Companion to other RDL® Remote Controls
The front panel of the RC2‑ST features two pushbuttons with two associated LEDs. Upon initial power‑up, source 1 is selected. Touching the other button de‑selects source 1 and immediately selects source 2. An LED adjacent to each button shows which source is selected.
In a typical installation, the RC2‑ST may be used to select between two audio or video sources, or to route audio to two destinations. To select between two audio sources, the RC2‑ST is connected to an RDL ST‑SSR1 Solid‑State Audio Switch. For video switching, an RDL TX‑MVX may be used. For audio routing, an RDL ST‑RX2 is used. In each of the above examples, only one output terminal is needed for triggering. Therefore a single shielded pair (or 3‑conductor cable) is required for remote connection. For more complex switching networks, both outputs may be used.
In installations where ULTRASTYLE™ wall controls are preferred, use the RUC‑4 Universal Remote Control.
Download RDL RC2-ST Data Sheet
Typical Performance: |
Selectors (2): | Momentary pushbuttons, (1 for each channel) | Indicators (2): | Red LEDs, (indicates channel selected) | Connections: | Power input; open‑collector outputs (25 mA current limited) | Mounting: | Mounts in US electrical box or RDL international wall boxes WB‑1U, WB‑2U; decorative plate available separately | Power Requirement: | GROUND‑REFERENCED, 24 to 33 Vdc @ 30 mA | Ambient Operating Environment: | 0° C to 55° C |
|