Ashly KLR-2000, Power Amplifier 2 x 1000W

Ashly KLR-2000 Power Amplifier 2 x (1 000W @ 2) (600W @ 4) (350W @ 8) Ohms

Our KLR Series are high-efficiency high-power 2-channel amplifiers that are the ideal choice for high-output speaker systems line arrays dual 18” subwoofers and much more.

If you think you need to use an expensive European amplifier to get a clean stable quiet amplifier—think again. KLRs are quiet with signal-to-noise ratio ratings from >108 dB to >110 dB across all models. They’re also versatile each with a 3-position gain switch for both channels a 3-position mode switch (bridged stereo or parallel mono) and a 3-position 12dB/oct HPF switch (30Hz 50Hz or off).

Exceptionally lightweight for their class all KLRs are designed in standard 2RU enclosures.Packed with features KLRs make a great choice when you need to value engineer a distributed sound system.

• Rated for 2 Ohms operation
• Balanced inputs via 3-pin Euroblock
• Combo XLR/TRS connectors
• Neutrik® speakON® type output connectors
• Switch-mode power supply with extensive protection circuitry
• On/off limiter switch • Forced-air cooled (front-in rear-out)
• Removable dust filters easy to clean
• Front-mounted attenuators
• Removable amp handles for permanent installation
• Optional locking front panel volume knobs
• Safety/Compliance: cCSAus CE FCC RoHS

Architect & Engineering Specs

The two-channel power amplifier shall incorporate the latest amplifier technology to deliver a minimum power of 1 000 Watts per channel into 2 Ohm loads 600 Watts RMS per channel into 4 Ohm loads or 350 Watts RMS per channel into 8 Ohm loads with both channels operating. The amplifier shall have rear panel switching for parallel mono and bridging modes. When switched into bridged-mono mode the amplifier shall deliver 2 000 Watts into a 4 Ohm load. The amplifier protection shall include output over-current DC output chassis temperature and a mains circuit-breaker. Frequency response shall be 20Hz–20kHz (1W @ 8 Ohms). The Signal-to-Noise Ratio shall be greater than 108dB at rated power into 8 Ohms (unweighted). THD shall be less than 0.05% into 4 Ohms 20Hz–20kHz and 10dB below rated power. The amplifier shall have a channel attenuator for each input on the front panel and input sensitivity select switch a high-pass filter switch and limiter enable switch on the rear panel. The inputs shall be of balanced bridging type with XLR ¼” TRS and 3-pin Euroblock connectors. The outputs shall be four pin SpeakON type connectors. LED type indicators shall be employed to show the relative power level of each channel clip/protect and power on/off. Self contained forced air cooling (front in) shall be used with front panel mounted removable dust filters. The power amplifier shall weigh 26.2lbs/11.9kg net and mount in a standard 19 inch rack using two spaces (3.5 inches high). The power requirement shall be 120VAC or 240VAC ±10% 50–60Hz factory set.

SE Systems handles the full line of Ashly Audio products. Please contact our showroom to inquire about pricing or to order products. 1-800-662-1312